FUJITSU MHT2060BH - Manual (Page 35)

1.11 Advanced Power Management
C141-E203-01EN 1-13
Active Idle: The head is in a position of extreme inner in disk medium.
Low Power Idle: The head is unloaded from disk.
The spindle motor rotates.
Standby: The spindle motor stops.
Table 1.7 Advanced power management
APM Mode Active Idle
Low Power Idle
(Unload)
Standby
(Spin Off)
Mode-0 0.2-1.2 sec 15 min. N/A
Mode-1 0.2-1.2 sec 10.0-40.0 sec N/A
Mode-2 0.2-1.2 sec 10.0-40.0 sec 10.0-40.0 sec
When the maximum time that the HDD is waiting for commands has been
exceeded:
Mode-0: Mode shifts from Active condition to Active Idle in 0.2-1.2, and to Low
Power Idle in 15 minutes.
Mode-1: Mode shifts from Active condition to Active Idle in 0.2-1.2 seconds and
to Low Power Idle in 10.0-40.0 seconds.
Mode-2: Mode shifts from Active condition to Active Idle in 0.2-1.2 seconds and
to Low Power Idle in 10.0-40.0 seconds. After 10.0-40.0 seconds in
Low Power Idle, the mode shifts to standby.
* The default values of these settings are reflected in the WORD 91 values of
the IDENTIFY DEVICE command. Also, the APM mode is initialized to
Mode-1 (default value) by a hardware reset and at power-off.