FUJITSU TeamPoS 7000 - Manual (Page 33)

THIS DOCUMENT CONTAINS CONFIDENTIAL INFORMATION, IS PROVIDED FOR FUJITSU CUSTOMER USE ONLY,
AND IS NOT TO BE SHARED WITH ANY THIRD PARTY WITHOUT FUJITSU’S PRIOR WRITTEN CONSENT.
TeamPoS7000_User Guide_D900000454.pdf Chapter 4 - Daily Maintenance
Revision 1.0 - March 6, 2012 Cleaning the Equipment - 31
4
Daily Maintenance
This chapter describes how to clean the equipment and replace consumables.
4.1 Cleaning the Equipment
The following cleaning operations must be performed as required in order to ensure reliability.
NOTE: Observe the following cautions when cleaning the equipment.
• Switch off the equipment before cleaning.
• Use a solution of mild detergent diluted in water to clean the exterior
surfaces.
• Do not use a wet or chemically treated cloth or volatile chemicals
such as paint thinner to clean the equipment. Doing so may damage
the surface.
4.1.1 Cleaning the main unit
Wipe the surface with a soft cloth such as gauze that has been moistened with neutral detergent.
The red rectangles in following illustrations show the ventilation holes on the A100 and A200/
A300 models. These holes must be kept clean and remain unobstructed in order to prevent
excessive internal temperatures.
Caution: When cleaning, never spray any liquids directly onto the unit.
Always spray onto a cleaning cloth and then wipe to clean.
A100 A200/A300