Fisher & Paykel OR60 - Manual (Page 74)

72
Care and cleaning
FOUR FUNC
TION MODELS
MODELS
WITH CER
AMIC GLASS C
OOK
T
O
P
Cleaning the enamel cavity
Clean the enamel on the inside of the oven when it has cooled down, using household
detergents or an ammonia-based cleaner. You may use ‘off the shelf’ oven cleaners, if you
carefully follow the manufacturers’ instructions.
Caring for the catalytic panels
The catalytic panels are covered with a special microporous enamel which absorbs and
does away with oil and fat splashes during normal cooking over 200 °C. If, after cooking
very fatty foods, the panels remain dirty, heat the oven on maximum for an hour to an
hour and a half, and they will self-clean. The side panels are reversible. Make sure that
you replace them with the arrow up, and on the correct side. To remove the side catalytic
panels, you first need to unscrew the side racks. See Fig. 76.
When you replace the panels, make sure that:
The arrows are pointing upwards.
Then screw the side racks back onto the oven wall.
Note: in some models, the back panel of the oven is also a catalytic panel, but this is not
reversible and should not be removed.
Cleaning the fat filter
Clean the fat filter after every use. If the filter is not cleaned, it will block and shorten the
life of the fan element. If it is lightly soiled, place the filter in a dishwasher on normal wash.
If the filter is very dirty, place in a saucepan with either two tablespoons of clothes washing
powder, or one tablespoon of dishwashing powder. Bring to the boil and leave to soak for
at least 30 minutes.
Rinse the filter in clean water and dry.
Fig.78 Fat fi lter