FUJITSU C150-E146-02EN - Manual (Page 59)

5-1
Basic Product Specification
No. Item Specification Remarks
1 Operating method ADF (Duplex), Flatbed
2 Image sensor CCD x2 Front/Back
3 Light source Inert Gas (Xenon) Lamp x2 Green
4 Document Minimum A8 (Porait)
Size Maximum A3/Double Letter
5 Document Thickness 52 g/m 2 (14lb) to 127 g/m 2 (34lb) Note *1
6 Optical Resolution 400 dpi
7 Output Binary 100/150/200/240/300/400/600 dpi
Resolution5 Grayscale 100/150/200/240/300/400 dpi Simplex
100/150/200 dpi Duplex
8 Grayscale level (internal) 1024 levels (10bit)
9 Scanning Simplex 50ppm, 200dpi, A4, Portrait
Speed 35ppm, 300dpi, A4, Portrait
(Engine Speed) 45ppm, 300dpi, A4, Landscape
Note*2
Duplex 90ipm, 200dpi, A4, Portrait
60ipm, 300dpi, A4, Portrait
80ipm, 300dpi, A4, Landscape
10 Halftone patterns Dither/ Error diffusion
11 Capacity of ADF 100 sheets (A4, 64 g/m 2 (17lb)) Note *3
12 Compression MH/MR/MMR Note *4
13 Interface SCSI-2 High Density
Note *5 50-pin, Female
Third Party Slot Note *6,
11
Note *1: The details are described in the chapter 4.
*2: The actual scanning speed might differ due to host computers’ environment.
*3: The maximum number will differ due to the paper thickness. Refer to the chapter 4.
*4: The scanning speed might be slow. The usage with NO COMPRESSION is recommended.
*5: Both SCSI-2 and the Third Party Slot can not be used at the same time.
*6: The Power consumption of the boards should be follows:
-In the Low Power Mode: Less than 0.35 A
-With IPC-4D option:
Less than 1.5 A
-Without IPC-4D option: Less than 3.0 A