FUJITSU MAX3036RC - Manual (Page 7)

C141-E237 iii
Important Alert Items
Important Alert Messages
The important alert messages in this manual are as follows:
A hazardous situation could result in minor or moderate personal injury if the
user does not perform the procedure correctly. Also, damage to the product
or other property, may occur if the user does not perform the procedure
correctly.
Task Alert message Page
Installation Damage
Never remove any labels from the drive or deface them in any way. 4-3
High temperature
To prevent injury, never touch the drive while it is hot. The DE and LSI
become hot during operation and remain hot immediately after turning off
the power. 5-1, 5-10
Damage
1. When dismounting the drive which is mounted on the
system while power is supplied to it.
• The spindle motor can be stopped by a START/STOP command. It
takes about 30 seconds for the spindle motor to stop completely.
• Then, dismount the drive using the drive mounting/dismounting
mechanism, etc. of the system. If the drive is dismounted while the
spindle motor is running, special care is required to avoid excessive
vibration or shock to the drive. Just in case, stop dismounting once
when SAS connector breaks off contact and wait until the spindle
motor stops (about 30 seconds.).
• When storing or transporting the drive, put it in the antistatic bag
(refer to Section 5.1).
5-10