FUJITSU MAX3036RC - Manual (Page 37)

3.2 Logical Data Block Addressing
C141-E237 3-9
(1) Block address of user space
The logical data block address number is consecutively assigned to all of the data blocks in the user
space starting with 0 to the first data block.
The HDDs treat sector 0, track 0, cylinder 0 as the first logical data block. The data block is
allocated in ascending order of addresses in the following sequence (refer to Figure 3.5):
1) Logical data blocks are assigned in ascending order of sector number in the same track.
2) Subsequent logical data blocks are assigned in ascending order of track number in the same head.
Within the same track, logical data blocks are assigned in the same way as step 1).
3) Subsequent logical data blocks are assigned to sectors in every track except the last track in
ascending order of track number in the same cell. Within the same track, logical data blocks are
assigned in the same way as step 1) and 2).
4) For the last track in the same cell, subsequent logical data blocks are assigned to sectors other
than spare sectors in ascending order of sector number.
5) After blocks have been assigned in the same cell according to steps 1) to 4), subsequent logical
data blocks are assigned in ascending order of cell number in the same way as in steps 1) to 4).
Logical data blocks are assigned starting from track 0 in the next cell until the last cylinder
(immediately preceding the alternate cylinder n-1 shown in Figure 3.1) of the zone except
alternate cylinders in cells in the user space.
When the logical data block is allocated, some sectors (track skew and head skew) shown in Figure
3.5 are provided to avoid waiting for one turn involving head and cylinder switching at the location
where the track or the head is physically switched.
See Subsection 3.3.2 for defective/alternate block treatment and the logical data block allocation
method in case of defective sectors exist on the disk.
(2) Alternate
area
Alternate areas in the user space (spare sectors in the cell and alternate cylinders) are not included in
the above logical data block addresses. Access to sectors which are allocated as an alternate block in
the alternate area is made automatically by means of the HDDs sector slip treatment or alternate
block treatment (explained in Subsection 3.3.2), so the user does not have to worry about accessing
the alternate area. The user cannot access with specifying the data block on the alternate area
explicitly.