FUJITSU fi-5530C - Manual (Page 10)

2
1.3 Operator panel
The operator panel is located on the right side of the
scanner. The panel consists of a Function Number Dis-
play, four buttons and a LED.
.
*) About the settings on the launcher, refer to FUJITSU
TWAIN32 scanner driver help and the "fi-5530C
Operator’s Guide" on the Setup CD-ROM.
■ Indications on the Function
Number Display
The following shows the indications on the Function
Number Display.
Name Function
Function Number
Display Indicates the state of the scan-
ner. The meaning of the num-
bers and alphabets indicated are
explained later in this section.
But-
tons Function Changes the Function activated
by the Send to button (*).
Send to Launches the linked application
software (*).
Scan
Power button Turns the scanner ON and OFF.
LED - Lights when the scanner is
turned ON.
Function No.
display
Function
Send to
Scan
LED
Power button
Indication Meaning
8
Lights only one time upon turning on the
scanner.
P
Indicates that the scanner has been turned
ON and is being initialized.
0
Indicates that initialization will soon be
completed.
1
Indicates that initialization has been com-
pleted successfully.
This status is called "Ready Status".
U
Indicates that a temporary error (that users
can solve) has occurred during the initial-
ization or scanning of documents.
"U" and an error number (1, 2, 6) are dis-
played alternately.
To return the scanner to the ready status
("1"), press the "Scan" or "Send to" button
while the error is indicated.
E
Indicates that a device alarm (that users can
not solve) has occurred during the initial-
ization or
scanning of documents.
"E" and an alarm number (2 to 9, and, c, d,
F) are indicated alternately.
To return the scanner to the ready status
("1"), press "Scan" or "Send to" button.
If this alarm occurs, turn the power off and
then on again. If the alarm is indicated after
turning on the power again, contact your
service engineer.