FieldServer Honeywell Zellweger IR-148 - Manual (Page 7)

FS-8700-102 Honeywell Zellweger IR-148-8_8-Channel Manual Page 7 of 17
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
5.2 CLIENT SIDE NODE DESCRIPTORS
Section Title
Nodes
Column Title
Function Legal Values
Node_Name Provide name for Node
Up to 32 alphanumeric
characters
Node_ID
Irrelevant for this driver when only one Node is connected.
Otherwise the Node-ID should be the number of
points/sensors for which the Zellweger unit is configured. A
unique Node_ID is recommended for each Zellweger Unit as it
may be useful in exposing Node status information
0-255
Protocol Specify protocol used InfraTox, Infra-Tox.
Port
Specify at which port the device is connected to the FieldServer
Ports P1-P8 require a 232/485 converter.
P1-P8
2
, R1-R2

Example
// Client Side Nodes
Nodes
Node_Name, Node_ID, Protocol, Port
DEV1,
1, InfraTox, R1
5.3 CLIENT SIDE MAP DESCRIPTORS
5.3.1 FieldServer Related Map Descriptor Parameters
Column Title Function Legal Values
Map_Descriptor_Name Name of this Map Descriptor Up to 32 alphanumeric characters
Data_Array_Name
Name of Data Array where data is to be
stored in the FieldServer One of the Data Array names from “Data
Array” section above
Data_Array_Offset Starting location in Data Array
0 to maximum specified in “Data Array”
section above
Function Function of Client Map Descriptor. Passive_Client
5.3.2 Driver Related Map Descriptor Parameters
Column Title Function Legal Values
Node_Name Name of Node to fetch data from
One of the Node names specified in “Client Node
Descriptor” above
Length Length of Map Descriptor 0 to Data_Array_Length (See Section 4).
Extended_Storage*
Expand Storage per point. Refer to
Appendix A.1
Yes , No
2 Ports P1-P8 require a 232/485 converter.