FujiFilm 30i User Manual

Page 49

Notes on the SmartMedia

™

Notes on the Power Supply

■SmartMedia

The SmartMedia card supplied with your FinePix30i
camera is a new image recording medium developed
especially for use in digital cameras. Each SmartMedia
card contains a built-in semiconductor memory chip
(NAND flash memory) which is used for storing digital
image data.
Because the data is stored electronically, the stored image
data can be erased from the card and new data recorded.

■SmartMedia with IDs

The SmartMedia ID is a SmartMedia that has an
individually assigned identification number. SmartMedia
ID cards can be used with devices that use ID numbers
for copyright protection or other purposes. This camera
accepts SmartMedia ID cards in the same way as
conventional SmartMedia cards.

■Storing Data

In the situations listed below, recorded data may be
erased (destroyed). Please note that Fuji Photo Film
Co., Ltd. accepts no responsibility whatsoever for the
loss (destruction) of recorded data.

✽When the SmartMedia is used incorrectly by the

owner or a third party

✽When the SmartMedia is exposed to static electricity

or electrical noise

✽When the battery cover is opened or the SmartMedia

removed and the camera is then switched off during
data recording, during data erasing (SmartMedia
formatting) or during frame advance when images are
being played back.

Back up important data onto another medium.
(MO disk, floppy disk, hard disk, etc.)

■Notes on Handling SmartMedia

h Take care to hold the SmartMedia straight when you

load it into your camera.

h Never remove the SmartMedia or switch the camera

off during data recording, during data erasing
(SmartMedia formatting) or during frame advance
when images are being played back. These actions
could result in damage to the SmartMedia.

h Use only the SmartMedia specified for use with the

FinePix30i. The use of other SmartMedia could
damage the camera.

h SmartMedia are precision electronic devices. Do not

bend, drop, or subject SmartMedia to excessive
shocks.

h Do not use or store SmartMedia in environments

likely to be affected by strong static electricity or
electrical noise.

h Do not use or store SmartMedia in very hot, humid or

corrosive environments.

h Take care not to touch the SmartMedia’s contact area

or allow the area to become soiled. Use a dry lint-free
cloth to wipe away any soiling that does occur.

h To avoid damage caused by static electricity, always

use the special static-free case provided during
transportation or storage, or keep the SmartMedia in
a storage case if available.

Always use the AC-3V AC Power Adapter (sold separately)
with the FinePix30i.
The use of an AC power adapter other than the AC-3V
could result in damage to your camera.
h Ensure that you do not touch the contact areas on the

AC power adapter against any other metal object as this
could cause a short circuit.

h Do not plug in the AC power adapter while you are

operating the camera using batteries. Switch the camera
off first.

h Do not load the batteries while you are operating the

camera using the AC power adapter. Switch the camera
off first.

h If you disconnect the AC power adapter when there are

no batteries in the camera, the date and time settings will
be lost and must be reset.

Specifications of the Enclosed Battery Charger BC-NHS

Rated input
Input capacity
Rated output

Wherever possible, use the battery charger in a well-
ventilated location.

h There may be vibration noises from inside the battery

charger during use. This is normal and does not indicate
a fault.

h Do not use the battery charger to charge batteries other

than FUJIFILM HR-3UF Ni-MH batteries.

h The battery charger could cause interference if placed

close to a radio during charging. In this event, move the
radio and charger further apart.

h Do not touch the connections or contact points on

rechargeable batteries with other metal objects as this
can cause a short circuit.

h Do not leave the battery charger in the following locations:

Locations subject to strong vibrations, in very dusty
locations, or in locations with very high humidity or high
temperatures, such as close to a heating appliance or in
direct sunlight.

h The battery charger accepts input voltages of 100-240 V AC

at 50 or 60 Hz and can be used outside Japan. However,
because the shapes of power sockets vary by country and
by region, an appropriate plug adapter is also required for
each country. Consult your travel agent for details.

100-240 V AC, 50/60 Hz
0.04 A-0.07 A
1.2 V DC, 400 mA

× 2

Applicable
batteries
Charging
time

Dimensions

Mass (Weight)
Operating
temperatures

FUJIFILM HR-3UF
(Ni-MH: 1500 mAh, 1600 mAh or 1700 mAh)
HR-3UF (1500 mAh): Approx. 3.8 hours
HR-3UF (1600 mAh): Approx. 4.5 hours
HR-3UF (1700 mAh): Approx. 5 hours
68 mm

× 90 mm × 26.5 mm

(2.7 in.

× 3.55 in. × 1.05 in.) (W × H × D)

Approx. 85 g (3.0 oz.) (excluding batteries)
0°C to + 40°C (+ 32°F to + 104°F)

Notes on Using the AC Power Adapter