56 7 audio recording, E movie – FujiFilm 30i User Manual
Page 26
51
3
50
e MOVIE
AUDIO/MOVIE MODE
●
!
Once the remaining time runs out, movie recording
automatically stops and the movie is stored on the
SmartMedia.
During shooting, “hREC” appears on the LCD
monitor with a counter showing the remaining
time displayed in the top-right corner.
●
!
The time required to record a 20 second movie
(roughly 3 MB) is approximately 3 seconds.
●
!
If you end shooting immediately after you start
shooting, only 3 seconds of movie is shot.
If you press the shutter button during shooting,
shooting ends and the movie is stored on the
SmartMedia.
5
6
7 AUDIO RECORDING
AUDIO/MOVIE MODE
1Set the Mode switch to “r”.
2The lens cover is closed when you switch the
camera on.
The available audio recording time is shown in the
top-right corner of the LCD monitor, while the elapsed
recording time and the “
£
” message are
shown in the center of the LCD monitor.
This mode allows you to record approximately 4
hours of sound at a time (using a MG-128SW).
●
Recording format: WAVE (
➡P.109)
PCM recording format
7 Audio Recording
●
!
Take care not to block the microphone (
➡P.8) with
your fingers, etc.
■ Standard audio recording times for SmartMedia
✽
These audio recording times are for newly formatted SmartMedia.
✽
The maximum length of the audio recording may be shorter than
4 hours depending on the available space on the SmartMedia.
SmartMedia capacity
Available recording time
MG-4S (4MB)
Approx. 8 min.
MG-8S (8MB)
Approx. 16 min.
MG-16S/SW (16MB)
Approx. 33 min.
MG-32S/SW (32MB)
Approx. 67 min.
MG-64S/SW (64MB)
Approx. 135 min.
MG-128SW (128MB)
Approx. 272 min.
■ Available recording time using batteries
(using the batteries provided when fully charged)
LCD monitor on
Approx. 80 min.
LCD monitor off
Approx. 240 min.
✽ To record sound for long periods, you should use the AC
Power Adapter AC-3V.
●
!
To switch the LCD monitor off, press the “DISP”
button before you begin audio recording.
1
2
0
1
0
2