FUJITSU C150-E140-03EN - Manual (Page 41)

M3091DC Image Scanner Operation Guide 3-5
3.2.2 Setting Documents
This section explains how to set documents.
Loosening documents
Before setting documents, sufficiently loosen them by the following
procedure:
• Remove a 4 mm thick section of pages, hold the ends of the
documents with both hands, and bend the documents.
• Hold the documents strongly with both hands so that both ends of the
documents are slanted, and then unbend the documents so that they
are inflated.
• Repeat the operations described above two or three times.
• Turn the document by 90
o
and similarly loosen it.
u Key point
The thickness of the documents to be set shall be 4 mm or less.
Failure to do so could result in the paper jam or the reading defect.
Leveling both ends and setting the documents
Level both ends of the documents so that they can be read correctly.