Fisher & Paykel DS602 - Manual (Page 21)

20
OPTION ADJUSTMENT MODE
After using the DishDrawer, you may want to change some of the preset options to suit
your needs. You can change the following settings:
• Rinse Agent
• Auto Power
• Water Pressure
To make these changes it is necessary to enter into the Option Adjustment Mode
To Enter the Option Adjustment Mode
• Press the Power button to turn the DishDrawer on.
• Press and hold the Program and Eco Save button simultaneously for five seconds.
• When the buttons have been pressed correctly the DishDrawer will give one long
beep.
• Release the two buttons. Use the buttons on the primary and secondary control
panel to make your changes to the pre set options. These are explained below.
• Press Power to return to the Normal mode. Your DishDrawer will save these
changes automatically.
• To make further changes repeat the above steps.
Rinse Agent Setting
• Enter the Option Adjustment Mode as explained above.
• The current rinse agent setting is shown on the secondary control panel in orange
lights.
• Press the Program button to advance the setting. The options are from one to five.
For example two orange lights indicate the rinse agent setting is set at two. Select
the setting you require.
• Press Power button to return to the Normal mode.