Lock – Fisher & Paykel DS602 User Manual

Page 10

Figure 2 - Display

showing the lock mode

Start / Pause

This button has a number of functions. It serves to:

Start the DishDrawer once the desired wash program has been selected.

Interrupt the wash program while in operation.

To pause the DishDrawer, press the Start / Pause button and wait until you

have heard two additional beeps before you open the drawer, allowing the lid

seal to deflate. While in pause mode, the light above the Start / Pause button

will flash.

Restart the DishDrawer after being paused.

You may notice a delay after the Start / Pause button has been pressed. During

this time the lid seal will be inflating.

One Button Start.

This starts the DishDrawer and will run the last wash program used.

NOTE:

Under no circumstances do we recommend that you open the DishDrawer while in

operation unless you have pressed the Start / Pause button. If the drawer is opened

during the wash program, there is a possibility of getting wet, burnt, or damaging the

DishDrawer. There are safety mechanisms in place to stop the DishDrawer if it is

opened.

If a red light appears above the Start / Pause button, check the secondary control panel

and note which lights are lit up. If the red lights above the rinse and fast are lit this

indicates that the door was opened during the wash program. To remove this fault,

ensure the drawer is closed and press Power. The DishDrawer will now be ready to

start from the beginning of the wash program. You may have to add more detergent in

the dispenser and then press Start / Pause button to start the DishDrawer. The

DishDrawer will not restart where it was interrupted after a fault.

Lock

The Lock function disables all the other functions on the

DishDrawer. This function is useful when cleaning the

control panel and can also prevent children from turning

the DishDrawer on or off accidentally. This button can be

used when the DishDrawer is in operation and will remain

active until the Lock is deactivated.

To activate this function, press and hold the Lock button

until the red light above it appears continuously and is no

longer blinking. All the other buttons are now inactive.

To deactivate this function, press and hold Lock button

until the red light above this button has disappeared.