Fisher & Paykel DS602 - Manual (Page 13)

12
OPERATING INSTRUCTIONS
1. Ensure the filter plate and drain filter is clean and free of food debris. Check the
drain filter is flush with the filter plate and the spray arm is correctly on the
impeller.
2. Check there is rinse agent in the dispenser.
3. Remove all food scraps from the dishes, before loading the DishDrawer.
4. Load the dishes.
Overloading the DishDrawer may lead to poor wash performance. Ensure
there are no items blocking the spray arm path.
5. Pour detergent into the detergent dispenser, then close the dispenser door.
Use the steps on the detergent dispenser as a guide to the correct amount of
detergent to use. Where the detergent manufacturer has made recommendations
on quantities, we suggest you follow their instruction.
6. Select the wash program on the secondary control panel.
Touch the Program button until the desired wash program light shows on the
panel. The wash program has now been selected.
7. Select Eco Save (Optional)
If you would like the wash program to use less energy and time, Eco Save should
be selected by touching this button. The wash program light will be green.
8. Close the drawer.
9. Start the Wash Program.
Press the Start / Pause button to start the DishDrawer. To pause the
DishDrawer, press the Start / Pause button and wait for two additional beeps
before opening the drawer. When in the pause mode the light above the
Start / Pause button will be flashing.
10. End of Program
At the end of the program the DishDrawer will beep six times to let you know
that it has finished and the green light above the Start / Pause button will
disappear. At the end of a wash program it is normal to find some water in the
drain filter area and the drying fan will be on for a short period of time or until the
drawer is opened.
In the event of a power failure, the DishDrawer will stop until the supply power is
resumed. It will drain the water in the DishDrawer and restart in the same part of the
wash program it was in when the power failed.