Fisher & Paykel DS602 - Manual (Page 20)

19
Figure 19 - Filling the
Rinse Agent Dispenser
Rinse Agent Indicator Light
· If the rinse agent indicator light is red, then there is little or no rinse agent left in
the dispenser. Rinse agent should be added into the dispenser.
· If the rinse agent window is black, there is enough rinse agent for the wash.
How Much Rinse Agent to Use
The regulator may need adjusting to suit your water conditions. The lowest
setting is ‘1’ and the highest is ‘5’ (refer to Option Adjustment Mode).
· If your dishes have white streaks, or there is excessive foam in the
DishDrawer, reduce the setting.
· If your dishes have water marks, or if flecks are left on glasses after drying,
increase the setting.
Rinse Agent Dispenser
Rinse agent gives a streak free sparkling clean look
to glass and chinaware. It speeds up drying and
helps prevent metal from tarnishing.
We highly recommend that you regularly use liquid
rinse agent to give the best drying results. For best
drying results, periodically check the rinse agent
dispenser to see if it needs filling and fill when
empty.
The rinse agent dispenser is on the inside of the
drawer, located underneath the detergent dispenser.
The dispenser holds approximately 1.7 fluid oz of
rinse agent.
To Load the Rinse Agent Dispenser
· Turn the plug counter clockwise, about one
eighth of a turn and remove.
· Pour the rinse agent into the circular opening.
· Take care not to spill rinse agent into the drawer.
· Wipe any overflow to prevent excess foaming.
· Fit the plug back into the original position.
1