Frymaster 2424G - Manual (Page 31)

24G SERIES FLATBOTTOM GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-25
1.8.5 Leakage
Frypot leaks are usually due to improperly sealed high-limit, temperature probe or oil-return and
drain fittings. When installed or replaced, each of these components must be sealed with Loctite
PST567 sealant or equivalent to prevent leakage. In very rare cases, a leak may develop along one
of the welded corners of the frypot. When this occurs, the frypot must be repaired or replaced.
Frypot locations (indicated by arrows) where potential leaks could occur.