FUJITSU ETERNUS DX P3AM-3842-05ENZ0 - Manual (Page 11)

Chapter 1
Workflow
This chapter describes how to connect the ETERNUS DX Disk storage system to a server running Linux.
Procedure varies according to whether a single-path or multipath configuration is used.
When a Fibre Channel switch is used to make the connection, refer to the "ETERNUS DX Disk storage sys-
tems User's Guide -Server Connection- (Fibre Channel) Fibre Channel Switch Settings" and use the proce-
dure described.
The workflow is shown below.
Usable Multipath Drivers
• ETERNUS Multipath Driver
• VERITAS Volume Manager
• device-mapper multipath
Required Documents
• Server Support Matrix
• Server Support Matrix for FC-SWITCH
• ETERNUS DX Disk storage systems User's Guide -Server Connection- (Fibre Channel) Disk Storage System
Settings (ETERNUS DX80 S2/DX90 S2, ETERNUS DX410 S2/DX440 S2, ETERNUS DX8100 S2/DX8700 S2)
• ETERNUS DX Disk storage systems Server Connection Guide (Fibre Channel) ETERNUS DX Disk Storage Sys-
tem Settings for ETERNUS DX60/DX60 S2, DX80, DX90
• ETERNUS DX Disk storage systems Server Connection Guide (Fibre Channel) ETERNUS DX Disk Storage Sys-
tem Settings for ETERNUS DX400/DX8000 series
• ETERNUS DX Disk storage systems User's Guide -Server Connection- (Fibre Channel) Fibre Channel Switch
Settings
• ETERNUS DX Disk storage systems User's Guide -Server Connection- (Fibre Channel) for Linux Driver Set-
tings for Non-Fujitsu Fibre Channel Cards
• ETERNUS DX Disk storage systems User's Guide -Server Connection- (Fibre Channel/FCoE/iSCSI/SAS) for Linux
device-mapper multipath
• Web GUI User's Guide
• ETERNUSmgr Install Guide
• ETERNUSmgr User Guide
• Other manuals provided with each product (server, Fibre Channel Cards, Fibre Channel Card Driver, Multi-
path Driver, and VxVM)
11
ETERNUS DX Disk storage systems User's Guide -Server Connection-(Fibre Channel) for Linux
Copyright 2013 FUJITSU LIMITED
P3AM-3842-12ENZ0