FUJITSU FTP-627USL431 - Manual (Page 9)

9
FTP-627USL431/631
Command Contents
GS $ + n1 + n2 Vertical absolute position specification in page printing mode.
GS & +m + x + y1 + y2 + d1 to dn Registered bit image definition.
GS' + m + n Registered bit image printing.
GS *+x+y1+y2 +d1+dn Registered bit image definition.
GS/ +m Registered bit image printing.
GS < Line feeds to the next mark.
GS A+m+n Sets the line feed length after mark detection.
GS B+m Angle setting of bar code.
GS E+n Sets print quality.
GS H+n HRI character printing position selection.
GS L+n1+n2 Left margin position setting.
GS M+n Printer ID demand.
GS W + n1 + n2 Printing area width setting.
GS Y +n1 + n2 Vertical relative position specification in page printing mode (vertical direction
of characters).
G a+n Automatic notification setting status.
GS e+n+m Sets bar code width.
GS f + n HRI character font selection.
GS h+n Sets bar code height.
y) GS k+m +d1to dk + NUL Bar code printing.
x) GS k+m+n+ d1 to dn
GS k+m+k1+k2+k3+k4+{[p1][d(1,1)] ~ Print of 2Dcode (QR).
[d(1,i)} ~ {[pi][d(i,1)]~[d(i,j)} [00]16
GS k+m+k1+k2+k3+k4+k5+d1~dn Print of 2 Dcode (maxi).
GS k+m+k1+k2+k3+k4+k5+k6+d1~dn Print of 2 Dcode (PDF417).
GS v Notification of firmware version.
GS w+n Sets bar code length.
GS (+c+m1, n2, m+fn+6 +d1~dn Customize printer
Commands continued
* : These commands are valid with FTP-627DSL600 series.