HP ACC2 Aurora - Manual (Page 19)

19
CHAPTER 9 CONFIGURATION FILE:
The configuration file is named c:\acc\config\config.acc .
This file must exist. The file contains comments which explains
the file. When the user knows the setup of the camera he can
fill inn the correct parameters in this file. Because the upper
case characters "A" - "Z" are used as comment identifier, these
characters should not be used.
Here is an example of a configuration file:
# #### #### # # ##### # #### ## ### ###
# # # # # ## # # # # # # # # # #
# # # # # # # ##### # # # # # #
# # # # # # # # # ##### ##### # # #
# # # # # # ## # # # # ## # # # # # #
# #### #### # # # # #### ## # # ### ###
#
#
# config.acc
#
#
# This file must be at c:\acc\config directory.
#
# This file is read when the ACC2 program is starting.
# This file contains the ACC2 configurations
# Lines starting with # are omitted (i.e. these lines are comment lines).
#
#
# ------------------------------------------------------------------------
# ---------- THIS IS FOR THE CAMERA OPERATION ---------------------------
# ------------------------------------------------------------------------
#
#
# This information is for the CameraConfigStruct . . . . . . . . . . . . .
#
# Location of RUN.ACC file : ACC_RUNDIR
# The RUN.ACC file determines if the camera is run or not.
#
ACC_RUNDIR c:\acc\seq
#
# Location of the sequence directory : ACC_SEQDIR
#
ACC_SEQDIR c:\acc\seq
#
#
# Location of the smartmtr macros: ACC_MACROS
#
# On Unis/UiO camera 1 :
#
# pmis
# |__ macros
# |__ Smartmtr
# |__ Test
#
# ACC_MACROS c:\pmis\macros\Smartmtr
#
# On Unis/UiO camera 2 :
#
# pmis
# |__ images
# |__ Macros
# |__ Norway