Hobart Welding Products CYBERTIG 350LX - Manual (Page 22)

OM-356 Page 18
1
3-10. Placing Jumper Links And Connecting Input Power
Ref. ST-801 973-A
Check input voltage available at
site.
1 Jumper Link Label
Check label – only one is on unit.
2 Jumper Links
Move jumper links to match input
voltage.
3 Input And Grounding
Conductors
Select size and length using Sec-
tion 3-9.
4 Line Disconnect Device
Select type and size of overcurrent
protection using Section 3-9.
Close and secure primary door.
Y Special installation may be
required where gasoline or
volatile liquids are present –
see NEC Article 511 or CEC
Section 20.
3/8 in
Tools Needed:
230 VOLTS 460 VOLTS 200 VOLTS
L L L L L L
S-083 566-C
2
GND/PE
Earth Ground
3
Connect GND/PE
Conductor First
Connect GND/PE
Conductor First
230 VOLTS
L L
460 VOLTS
L L
S-010 587-B
575 VOLTS
L L
4
L1
L2
1
Green