Honeywell VISTA-128BP - Manual (Page 36)

– 36 –
Arming Perimeter Only
(With Entry Delay ON)
Using the 3 STAY key
Use this key when you are staying home, but might expect someone to use
the entrance door later.
When armed in STAY mode, the system will sound an alarm if a protected
door or window is opened, but you may otherwise move freely throughout the
premises. Late arrivals can enter through the entrance door without causing
an alarm, but they must disarm the system within the entry delay period or
an alarm will occur.
The system provides three STAY modes. STAY mode 1, 2, and 3. STAY
modes 1 and 2, when activated, automatically bypass specific zones assigned
by the your installer to each of the STAY modes. STAY mode 3, when
activated, automatically bypasses all zones assigned to STAY modes 1 AND
2. Check with your installer for a list of the zones that are bypassed during
each STAY mode.
Close all perimeter windows and doors before arming (see
CHECKING FOR OPEN ZONES section)
STAY
1. Enter your security code and press 3 + 1 for STAY Mode 1.
Enter your security code and press 3 + 2 for STAY Mode 2.
Enter your security code and press 3 + 3 for STAY Mode 3.
NOTE: If none of the zones in a partition are assigned to Stay mode 2, then
when the user enters [User Code] + [3] (STAY), all zones assigned to Stay
mode 1 are automatically bypassed.
2. ARMED ***STAY 1*
ZONE BYPASSED
The keypad beeps three times, displays the
armed message, and indicates which STAY
mode (1, 2 or 3).
Note: "ZONE BYPASSED" in this display
simply indicates that some zones of protection
are not armed when using STAY mode.