Husqvarna 232R - Manual (Page 26)

26
– English
MAINTENANCE
Spark plug
The condition of the spark
plug is affected by:
• An incorrect carburettor
setting.
• An incorrect fuel
mixture (too much or
faulty oil).
• A dirty air filter.
These factors cause
deposits on the spark plug
electrode that may result in
malfunction or starting
difficulties.
If the machine is low on power, difficult to start or runs
poorly while idling always check the spark plug first.
If the spark plug is dirty, clean it and at the same time check
that the electrode gap is 0.5 mm. The spark plug should be
changed after about one month of operation or earlier if
necessary.
NOTE! Always use the recommended type of spark plug. An
incorrect spark plug can damage the cylinder/piston.
0,5 mm
Air filter
The air filter should be
cleaned regularly removing
dust and dirt to avoid:
• carburettor malfunction
• starting problems
• reduced engine power
• unnecessary wear to
engine parts
• abnormal fuel
consumption
Clean the filter after every
25 hours or more regularly
if operating conditions are
exceptionally dusty.
Cleaning the air filter
Dismantle the air filter
cover and remove the air
filter. Wash in clean, warm
soapy water. Ensure that the
filter is dry before refitting. An air filter used for a long period
of time can never be cleaned completely. Therefore it is
necessary to replace the filter from time to time with a new
filter. A damaged air filter must always be replaced.
The end of the drive axle in
the lower shaft should be
lubricated with grease every
30 hours. There is a risk that
the drive axle ends (splined
coupling) on two-part shafts
jam if they are not lubricated
regularly.
Two-part shaft
Angle gear
The angle gear is filled
with a sufficient quantity
of grease at the factory.
However, before using the
machine you should check
that the angle gear is filled
to 3/4 with grease. Use
HUSQVARNA special
grease.
Normally, the grease does
not need to be changed
except when the angle gear
is repaired.
!
WARNING!
Always discard a blade that is bent,
twisted, cracked, shattered or damaged in
any other way. Never attempt to straighten
a twisted blade for use again. Only use
original blades of the prescribed type.
• See the cutting
equipment’s packaging
for correct filing
instructions.
• The blades are sharpened
using a single cut flat file.
• Sharpen all edges equally
to maintain the balance
of the blade.
WARNING!
Always stop the engine before you start
work on any part of the blade. The blade
continues to rotate even after the throttle
has been released. Ensure that the blade
has stopped completely and remove the
cable from the spark plug before you start
to work with it.
!
Filing the grass blade