Husqvarna 232R - Manual (Page 16)

16
– English
Assembling the handlebars
(225R/RD/ 232R/RD)
ASSEMBLY
Assembling the handlebars (235R)
• Remove the screw at the
rear of the throttle handle.
• Slide on the throttle
handle on the right-hand
side of the handlebars, (see
the diagram).
• Align the hole in the
throttle handle for the
fixing screw with the hole
on the handlebars.
• Refit the screw in the rear
of the throttle handle.
• Fit the screw through the
throttle handle and the
handlebars and tighten.
• Unscrew the bracket
components from the
handlebar bracket.
• Position the handlebars as
shown. Fit the bracket
components and tighten
the handle lightly.
• Fit the cabling as shown.
• Put on the harness and
hang the machine in the
suspension hook. Now
finely adjust so that the
machine gives a
comfortable working
position when it‘s
attached to the harness.
Tighten the handle.
• Remove the screw at the
rear of the throttle
handle.
• Slide on the throttle
handle on the right-hand
side of the handlebars,
(see the diagram).
• Align the hole in the
throttle handle for the
fixing screw with the
hole on the handlebars.
• Refit the screw in the
rear of the throttle
handle.
• Fit the screw through the
throttle handle and the
handlebars and tighten.
• Unscrew the handle
from the handlebar
bracket.
• Position the handlebars
as shown. Fit the bracket
components and tighten
the handle lightly.
• Put on the harness and
hang the machine in the
suspension hook. Now
finely adjust so that the
machine gives a
comfortable working
position when it‘s
attached to the harness.
Tighten the handle.