Harmar Mobility AL010 - Manual (Page 4)

Hitch Adapters
Bumper Mount
( Be sure to comply with
vehicle's bumper rating )
CLASS 1
( Flat Bar Style )
CLASS 2
( 1.25 x 1.25 Solid Bar )
Omit stabilizer
CLASS 3
( 2 x 2 TUBE )
Refer to Section 4 or 5
for proper orientation
( right side up or upside down )
Determines lift's height from
the ground
PINCH BOLT
SLEEVE
FOR AL030 ONLY
( CLASS 1 )
Before installing an outside lift on your vehicle the vehicle must be equipped with the correct hitch. If
you are unsure whether your vehicle has, or can accept a hitch, contact your local hitch installer or
visit www.hitch-web.com for vehicle hitch compatibility information.
Please note, your lift comes equipped with a license plate hold light. To power this light vehicle must
have a standard 4-contact trailer light harness. Contact your local hitch installer for more information.
Trailer light wiring is designed to power license plate light ONLY. Attempting to run your lift
from ANY secondary power sorce may cause your lift to operate poorly and could potentially
cause damadge to the motor. All Harmar lifts must be wired directly to the vehicle battery.
Hitch recievers MUST be installed so that it sits parellel to the ground. An improperly
installed hitch can affect the operation of your lift. Some vehicles will require supen-
sion to be supplemented. Contact your local hitch installer or refer to your vehicle’s
owners manual for further guidance.
The following pages will help
you to determine correct
hitch adapter positioning.