beautypg.com

Vehicle wiring instructions, Xcess wire here, Coil excess wire here – Harmar Mobility AL010 User Manual

Page 3: Or side mount top mount

background image

Vehicle Wiring Instructions

BL

AC

K

WI

RE

BL

AC

K

W

IR

E

OR

Side mount

Top mount

Unwind the harness and lay it flat on the ground. One end of
the harness has a black plug; this runs to the back of the
vehicle.

BEGIN ROUTING THE HARNESS AT THE VEHICLE BATTERY.
Connect the black wire to the negative terminal of the battery.
Do not connect the positive terminal yet.

Run wiring harness under, or if possible, through the vehicle,
using cable ties provided to secure the harness to the vehicle.
Position the harness away from the fuel tank, exhaust sys-
tem, brake and fuel lines and any possible pinch points.
Harness should be positioned where it will not come in con-
tact with any road debris.

The harness may be too long for the vehicle. DO NOT CUT
OR SHORTEN THE HARNESS. Use cable ties provided to coil
excess wire and secure it to the vehicle frame.Rear plug
should be secured even to the vehicle’s trailer hitch.

Connect the red wire to the positive battery

terminal.

Wire in a standard 4-contact female flat trailer
connector to the vehicle’s taililights. This will
provide power for the motor cover light.

TRAILER PLUG

ON LIFT HARNESS

MOTOR COVER

LIGHT

Ground for light is

provided by main

2 prong power

connector

BROWN WIRE

RE

D

W

IR

E

RED WIRE

OR

COIL

EXCESS

WIRE

HERE

RE

D

W

IR

E

RED WIRE

OR

Side mount

Top mount

XCESS

WIRE

HERE

To back

of vehicle

To vehicle's

battery

RE

Harness requires direct connection to
vehicle battery. Do not connect harness
to a secondary power source.

Coil

Excess Wire

Here

This manual is related to the following products: