HP 3C509B-TP - Manual (Page 37)

4 Connecting to a Windows NT Server 4.0
Windows NT Workstation Version 3.51
Windows NT
Workstation
Version 3.51
Requirements
• HP Vectra with Microsoft Windows NT Workstation 3.51 installed.
• 3COM Etherlink 3C509-B ethernet card and drivers disk ver. 5.0.Driver
Name: Elnk3.SYS Size: 27KB Date: 7/18/96
• Microsoft Windows NT Workstation 3.51 and Service Pack Media.
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Boot PROM Disabled
• Transceiver Type Auto Select
• Network Driver Optimization Windows or OS/2 Client
• Maximum Modem Speed 9600 Bps
• Plug and Play Compatibility Disabled
• Full Duple Disabled
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink III 3C509-B
adapter card into an ISA slot.
2 Connect network cable media to the 3COM 3C509B card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM Software “3C509-B Ethernet drivers disk
ver 5.0.” and execute “A:\3C5X9CFG.EXE.”
5 Select “CONFIGURE NIC” and verify the resource settings listed above
under the heading “Device Configuration.”
6 If changes are required, save those changes and exit.
Vectra VL8 Vectra VL7 Vectra VE7/VE8
I/O Base Address 210h 210h 300
Interrupt Request
Level
10 10 10