HP 3C509B-TP - Manual (Page 27)

3 Connecting to a Windows NT Server 3.51
Windows NT Workstation 4.0
Windows NT
Workstation 4.0
Requirements
• HP Vectra with Windows NT Workstation 4.0 Service Pack 3.
• 3COM Etherlink 3C509-B ethernet card and drivers disk ver 5.0.
Driver Name: Elnk3.SYS Size: 27KB Date: 7/18/96
• Microsoft Windows NT Workstation 4.0 and service pack media.
(If you have a Hewlett-Packard pre-loaded HDD, the media is located at
“C:\I386”)
• Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Boot PROM Disabled
• Transceiver Type Auto Select
• Network Driver Optimization Windows or OS/2 Client
• Maximum Modem Speed 9600 Bps
• Plug and Play Compatibility Disabled
• Full Duplex Disabled
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink III 3C509-B
adapter card into an ISA slot.
2 Connect network media to the 3COM 3C509B card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM Etherlink 3C509-B Ethernet card and
drivers disk ver 5.0. and execute “A:\3C5X9CFG.EXE.”
5 Select “CONFIGURE NIC”, and verify the resource settings listed above
under the heading “Device Configuration.”
Vectra VL8 Vectra VL7 Vectra VE7/VE8
I/O Base Address 210 210 300
Interrupt Request
Level
10 10 10