Humax CR-3510 - Manual (Page 23)

22
A/V Output Setting
Set the Audio mode which is output from RCA/Cinch Jack.
(Stereo/Mono)
Select the aspect ratio of TV which is connected to STB(4:3 or 16:9).
Select the format which the video is to be displayed on screen.
When your TV set is 4:3 and video source is 16:9,
STB will display in Letter-box or Center mode as selected.
When your TV set is 16:9 and video source is 4:3,
STB will display in the Pillar-box or Full mode as selected.
Adjust this value between 3.58 and 4.43 if your TV displays the video
only in black and white color. Normally NTSC 3.58 mode is used
worldwide, but some TV sets can support only NTSC 4.43 mode.
When you watch TV after connecting a cable between
the RF OUT jack on STB and the Input jack (RF Input) on TV.
If you select Channel 3 or Channel 4 and then set VHF Tuning to
Channel 3 or Channel 4, all services from STB will be viewed
through TV Channel 3 or Channel 4.
Select the OSD transparency and Information Box Display Time.
Select the OSD transparent type. It affects Information Box, Service
List, Time and Quick mode of TV Guide. Use the buttons to
toggle transparent and opaque.
Set the display duration of Information Box displayed on the screen
after changing services. The time ranges from 0 to 20 seconds.
Audio Output
Screen Mode
Display Format
NTSC Mode
OSD Transparency
Info. Box Display Time
Other Setting
VHF Tuning