Symptoms that seemingly appear to be failures, Troubleshooting, English – Hitachi CMP4202 User Manual
Page 27: Warning
ENGLISH
Symptoms That Seemingly Appear to be Failures
Make the checks suggested below depending on the symptoms observed. If the symptoms remain uncorrected, contact your dealer.
TROUBLESHOOTING
Customer servicing can be hazardous.
WARNING
Symptom
Point to check
See page
• No picture with the power-indicating lamp
off.
• Check the way the power cable is connected.
• Press the power switch.
• The message “NO SYNC SIGNAL” or
“POWER SAVE” is displayed.
• No picture with the power indicating lamp
lights in orange.
POWER SAVE
No sync signal is detected.
• Check the way the signal cable is connected.
• Make sure that the switch of the computer, imaging equipment ,
etc., is turned on.
• Make sure the computer is not in the power-save mode.
• Check to see if the input selection matches the connection
terminal.
• The message “OUT OF FREQUENCY” is
displayed.
OUT OF FRQUENCY
An input signal is not received normally.
• Check to see if the input signal matches the monitor specifications.
• Check the way the signal cable is connected.
• The power indicating lamp is normally lit but
no picture .
• Check the contrast and brightness settings (adjust them for higher
contrast and brightness).
• Check the way the signal cable is connected.
• The display image appears flowing
slantwise.
• Text displayed across the screen appears
vertically streaked, with the characters in
vertical columns blurred.
• Adjust the dot clock frequency and phase. (Adjust the dot clock
frequency first, the dot clock phase next.)
(RGB input)
• Text displayed across the screen appears
blurred.
• A fine pattern flickers when displayed on the
screen.
• Adjust the dot clock phase for the clearest viewing.
(RGB input)
• The remote controller does not work.
• Check to see if the batteries are loaded in the remote controller in
opposite direction.
• Check to see if the batteries in the remote controller are OK.
• The screen becomes dark and the images
cannot be seen during VTR special
playback (fast forward, rewind).
• This sometimes occurs when a component output VTR such as
the 480i is connected.
This is not a malfunction; therefore, please take note that this may
occur. When it does occur, change to composite output, or S1 (or
S2) output.
-
• The display image does not come out by the SCART signal.
• Check the way the signal cable is connected.
• Check the setup.