beautypg.com

Hitachi 32LD8800TA User Manual

Page 58

background image

55

TROUBLESHOOTING (continued)

Symptom and Check List (continued)

Symptoms

Check list

Page

No picture

The Indicating lamp → Off

Check if the Power Cord is plugged into the socket fi rmly.
Check if the Main Power is ON.

17

,

18

No picture

The Indicating lamp → Orange

It means that the unit is in “Power Save

mode”.

Check if all the cables of the external equipments are connected

correctly and fi rmly.

Check if the power of the external equipments is ON.
Check if the TV/AV mode has been selected correctly.
Check if the PC is in Power Save mode or not.
Refer to “Power Save mode” and “When following messages appears on

the screen”.

52

No picture

The indicating lamp → Green

Check if the signal cable is connected correctly and fi rmly.
Adjust the level of Brightness and Contrast lower.

14

~

16

The top of the monitor and surface of

the panel heat up.

It may happen when you use the unit for long hours. Turn off the Main

Power of the unit for a while. Please note that this is not malfunction.

57

,

59

Image cannot be displayed in the correct

position.

Press

button to check if the input signal of the displayed image is

compatible with the specifi cation of the monitor.

25

,

57

,

59

When the VCR is in special playback

features (Fast Forward or Rewind), the
screen gets dark and cannot see the
image at all.

It could happen when the VCR is connected to Component output, such

as 480i. This is not malfunction.

Try Composite output or S-video output and check the picture again.

The images are not displayed on sub

pictures in “Multi Picture mode”

There are some combinations of input signals that the images are not

displayed on sub pictures.

Please check the Table of “2-Picture” and “4-picture/2-picture (1080i)” for

details.

41

~

43

60

Screen display size cannot be switched

correctly.

The display size is fi xed at “FULL” when the receiving signals are

1080i/60Hz, 1080i/50Hz, 720p/60Hz, or 720p/50Hz.

Check the signal status by pressing the

button on the remote

control.

38

,

39

Cannot be displayed the image from

HDMI 1 or 2.

Check if the cables are connected correctly.
Check the output format of the equipments.
(Please refer to “Connecting Procedure” and “Recommended Signal

List”.)

57

~

59