Hitachi 32LD8800TA - Manual (Page 21)

18
ENGLISH
BASIC OPERATION
Power On/Off
Now, turn On the main power of the unit. Make sure that the Power Cord
has plugged into the wall socket.
To turn On the power of the monitor:
1. Press the Main Power switch on the monitor.
The Indicating Lamp will illuminates in Red (Standby mode).
2. Press Sub Power button either on the control panel or on the remote
control.
The color of the Indicating Lamp turns into Green, and the image will
display on the screen.
To turn Off the power of the monitor:
1. Press Sub Power button either on the control panel or on the remote
control.
The image disappears from the screen and the Indicating Lamp turns
into Red (Standby mode).
2. Press Main Power switch to completely turn Off the power of the unit.
The Indicating Lamp Status Check
Indicating Lamp
Status
Power Status Power Switch Status
Off Off Main power → Off
Red Standby mode
Main power → On
Sub Power button → Off
Green On
Main power → On
Sub power button → On
Orange Power Save mode*
Main power → On
Sub Power button → On
* About Power Save mode, see “Power Save Mode” and “When Following Messages Appear on the Screen” on
52
and 54 for details.
NOTE
If the image does not appear on the screen at all, or have any problem, see TROUBLESHOOTING on 54 ~ 56 . It
may help you to solve the problems.
You can turn ON the power only by pressing the Sub Power button during the Standby mode.
Do not switch the power On/Off repeatedly in a short period of time. It could cause malfunction.
To avoid sudden surges of electricity when the power comes back on, turn Off the main power of the unit before you
leave if there is a blackout during use of the unit.
Main Power switch (on the bottom surface)
Sub Power button
Sub Power button
P
P
SD MEMORY
CARD
PUSH-EJECT
OK
PH35814