Function (continued) power save mode – Hitachi 32LD8800TA User Manual
Page 55
52
ENGLISH
FUNCTION (continued)
Power Save Mode
When AV input is selected
You are provided the function to save power consumption when no signal is detected in AV input. Set to On in “Video
Power Save” from Function Menu, which leads to the power save mode in AV1 /AV2 /HDMI1 /HDMI2 and the
Standby mode in other AV input. (Please see the table below for details) Refer to
27
about “Video Power Save”.
When no signal is detected
When signal is input during
On in “Video Power Save”
Condition
Indicating Lamp
AV1, AV2,
HDMI1, HDMI2
Power Save
Orange
Turns On automatically.
AV3~AV5
Standby
Red
Remains as Standby mode.
When the RGB input is selected
When this unit is connected to a VESA DPMS computer, the Power Save mode (Operation mode : Off) can be set
to be activated automatically when the computer is not being used to reduce power consumption by this unit.
RGB sync signal
Horizontal
Yes
No
Yes
No
Vertical
Yes
Yes
No
No
PC signal
Active (normal display)
Blank (no display)
Operation mode
On
Off
Indicating lamp
Lights green
Lights orange
Returning to operating status
Operate the personal computer, or press either the INPUT SELECT button of the control panel or the RGB button
of the remote control.