Qr65422_01_eng_12-24_05110801.pdf, Anti-tumble measures, English – Hitachi 32LD8800TA User Manual
Page 15: Read safety precautions, Carefully besides this page, Securing to a wall or pillar, Securing on desktop, Securing to ceiling
12
ENGLISH
PREPARATION (continued)
Safety Precaution on Main Unit Installation
Read SAFETY PRECAUTIONS (
3
to
6
) carefully besides this page.
*When installing the monitor, use the Desktop Stand (SD8G4237/ optional for 37LD8800TA). Please refer to the user
manual of the stand. The Desktop Stand has been used for the illustration in this manual.
Anti-Tumble Measures
Install in a stable place and implement safety measure against overturning.
When installing the main unit, be sure to use the specifi ed mount units in order to obtain maximum performance
and maintain the safety.
We assume no responsibility or liability for personal injuries or property damages caused by use of other mount
units or improper installation.
As for the installation instruction, please read each user manual of the mount units: for Desktop Setup, Wall
Mounting, and Ceiling Mounting.
In case of using Wall or Ceiling Mounting unit, by contacting your local dealer, ask the specifi ed installation
specialist to set up. Never attempt to install it by yourself. It could cause injuries or damages.
Please leave the adequate space around this monitor in
order to avoid increasing the internal temperature and
keep safety while using swivel function.
Make sure not to block any ventilation holes.
Do not install the monitor in the small space such as
inside the rack, closet or the box.
Leave more than 10cm of clearance from each side of
monitor and 30cm from the top of monitor to wall.
Without Swivel function: Leave at least 10cm of clearance
behind rear monitor.
With Swivel function: Leave the adequate space to obtain
the maximum performance of Swivel Function.
(32LD8800TA:25cm/ 37LD8800TA:29cm)
Refer to
36
for Swivel Function.
10cm or more
*
Cord
or
chain
Clamp
Securing to a wall or pillar
Using a commercially available cord, chain, and
clamp, secure the set to a wall or pillar.
hook
cord or chain
screw
cord or chain
clamp
Wall or Pillar
Securing on desktop
Use two wood screws to secure the set fi rmly in
position by fastening them to the screw holes at the
rear of the stand as shown in the diagram.
For 32LD8800TA, please get
the commercially available
wood screws for the stand.
For 37LD8800TA, the wood
screws are supplied with the
optional stand.
Two places
Wood screw
Securing to ceiling
Using a commercially available cord, chain, and clamp, secure the set to a ceiling.
NOTE
For more information regarding the mounting of the unit, please contact your dealer.
Loosen a cord or chain enough while operating power swivel to avoid physical injury.
10cm
or more
10cm
or more
30cm
or more