Hand Held Products 2D IMAGER 4800P - Manual (Page 21)

4800p 2D Imager User’s Guide 2 - 1
2
Terminal Interfaces
Terminal ID
If your interface is not covered by a Plug and Play bar code from Chapter 1, then
refer to
Supported Terminals on page 2-2, and locate the Terminal ID number for
your PC. Scan the Terminal ID bar code below, then scan the numeric bar
code(s) from the Programming Chart inside the back cover of this manual to
program the imager for your terminal ID. Scan Save to save your selection.
For example, an IBM AT terminal has a Terminal ID of 003. You would scan the
Terminal ID bar code, then 0, 0, 3 from the
Programming Chart inside the back
cover of this manual, then Save. If you make an error while scanning the digits
(before scanning Save), scan the Discard code on the Programming Chart , scan
the Terminal ID bar code, scan the digits, and the Save code again.
Note: After scanning one of these codes, you must power cycle your computer.
Terminal ID
Save