Yamaha RM-CR Remote Conference Processor with Dante - Manual (Page 21)

Eng
lish
21
RM-CR Installation Manual
Network specifications
Input/output characteristics
[Dante/PoE] port
Dante Audio/Dante Control, remote control, WebUI, PoE+ supported
Cable requirements: CAT5e or higher, STP
Network ports
Corporate Network, remote control, SIP, WebUI
Cable requirements: CAT5e or higher, STP
[SETUP] port
USB2.0 micro, Network Class, WebUI, fixed IP
Cable requirement: USB cable (A-micro B type)
Input
Terminal
Actual Load
Impedance
For Use With
Nominal
Input Level
Connector
Nominal
Max.
Before Clip
MIC IN
1, 2
2.2 kΩ 50 – 600 Ω −46 dBu −26 dBu
XLR-3-31
(Balanced)
AUX IN
L, R
20 kΩ 1 kΩ −14 dBV +6 dBV RCA PIN
Output
Terminal
Actual Source
Impedance
For Use With
Nominal
Output Level
Connector
Nominal
Max.
Before Clip
AUX OUT
L, R
1 kΩ 10 kΩ −14 dBV +6 dBV RCA PIN
SP OUT
L, R
1 kΩ 10 kΩ −14 dBV +6 dBV RCA PIN