Yamaha RM-CR Remote Conference Processor with Dante - Manual (Page 15)

Eng
lish
15
RM-CR Installation Manual
Use the separately sold RM-MRK mounting accessory to install the unit.
Please read before mounting the unit into a rack
This product is warranted to operate in a temperature range of 0–40°C. If this product is
mounted in a rack together with other devices, there might be cases in which heat from the
various devices causes the temperature inside the rack to rise, so that the product is
unable to perform satisfactorily. To prevent the temperature inside the unit from rising,
mount the unit in the rack in accordance with the requirements below.
• If this product is mounted together with devices that are prone to produce heat, such as
power amps, leave at least 1U of space between it and other devices. Also, be sure to
maintain sufficient ventilation in this space by installing a ventilation panel or leaving it
open.
• Leave the rear panel of the rack open, and ensure that the rack is at least 10 cm away
from the wall or ceiling to allow sufficient air circulation. If you cannot open the rear panel
of the rack, install a commercially-available forced ventilation device, such as a fan kit. If
you install a fan kit, closing the rear panel may work better for heat dissipation purposes.
For more information, refer to the owner’s manual for the rack and/or fan kit.
INSTALLATION IN A RACK
Caution: If you plan to relocate the rack, be sure to first remove this unit
from the rack.
If this product is moved while mounted in a rack, vibration etc. might cause
the mounting accessory to deform or break, possibly causing injury. There is
also a possibility that this unit might malfunction.