Yamaha RM-CR Remote Conference Processor with Dante - Manual (Page 12)

12
RM-CR Installation Manual
Rear panel
1 [AUX IN] L/R jacks
These are RCA jacks (unbalanced) for audio input. Use these jacks if the audio from the
remote location is analog.
2 [AUX OUT] L/R jacks
These are RCA jacks (unbalanced) for audio output. Use these jacks if the audio to the
remote location is analog.
3
Speaker jacks
These are RCA jacks (unbalanced) for audio output. Use these jacks if the powered
speaker or power amp used in the remote location does not support Dante.
4 USB port
Use this port when connecting to a computer to exchange audio with a remote location.
Use the included USB cable (A-B type) for this connection.
5 Network ports
These are RJ-45 ports to which you can connect LAN cables (CAT5e or higher) for
remote administration and settings via the company network, etc.
DHCP is specified by default. If you want to use a specific IP address, use the web UI
to specify the IP address before connecting to the company network. For details on
settings, refer to “RM-CR Reference Manual.”
You can also connect to a public network for exchanging audio with a remote location
via the SIP protocol.
Notice : The maximum usable cable length is 100 meters.
: To prevent electromagnetic interference, use STP (Shielded Twisted Pair)
cables.
4 6 1 2 3 5 7