Pioneer Toraiz SQUID - Creative Multitrack Sequencer - Manual (Page 170)

Connecting to external equipment
170
En
Notes
• When setting the [MIDI THRU/OUT2] terminal to [THRU (MIDI IN)]
or [THRU (USB IN)] , the same timing clock as the one of the [MIDI
IN] terminal or the [USB-B] terminal will output from the [MIDI THRU/
OUT2] terminal.
• When converting from low timing clock to high timing clock (e.g.
when converting 1ppqn input to 24ppqn output), the timing clock may
not be output until the unit detects the BPM in the timing clock input.
• Depending on the external device to be connected, the BPM
displayed on the unit and the external device may be different.
• When setting the [CLOCK IN] terminal of the unit as the master clock
source of the low timing clock (1ppqn, 2ppqn, 4ppqn) and slave
operation of the unit, DIN SYNC compatible devices connected to the
[DIN SYNC OUT1] terminal or the [DIN SYNC IN/OUT2] terminal set
to [OUT] may be out of synchronization.
For synchronized playback with DIN SYNC compatible devices, we
recommend not using timing clock rate conversion from the low
timing clock, but using a master clock source of 24ppqn (Sync24) or
48ppqn (Sync48).
CV/GATE conversion
Convert the note information received from the [USB-B] or [MIDI IN]
terminal to the CV or Gate signals and output from the [CV OUT1] ,
[GATE OUT1] , [CV OUT2] , or [GATE OUT2] terminal.
Refer to “Connecting the unit to an external CV/GATE compatible
device to play” (page 158) on the setting of MIDI channel for CV/GATE
conversion.