Nissin MG10 Wireless Flash with Air 10s Commander (Nikon) - Manual (Page 22)

External Power Pack Socket (sell separately)
Connecting the Power Pack
Disconnecting Power Supply Cable
Make sure to switch o�ff both the Power Pack and the
flash unit before use.
!
Use the compatible flash power supply cable for MG10.
Hold the connector of the flash power supply cable
in front of the socket with both guide marks on the
connector and on the socket coinciding and insert
it into the socket straightly. You can plug the
connector into either socket 1 or socket 2. 1.
Make sure the Power Pack has been switched OFF. 1.
Connect the plug at the other end of the power
supply cable to the MG10. 2.
Hold the connector of the flash powter supply
cable as shown and pull it off. 2.
21