Nissin MG10 Wireless Flash with Air 10s Commander (Nikon) - Manual (Page 15)

14
Flash Exposure Control
M manual flash mode power control
1. Press the Group Selection button, the group letter blinks.
2. Rotate the Operation Dial to increase or decrease the flash power of the group selected.
The setting of M mode on Air 10s starts from 1/256 (minimum) to 1/1 (Full), and
controlled by 1/3 step intervals. The value digi displayed next to the group
only shows the integer step value (*).
3. When the M mode setting is completed, press the group selection button again.
CAUTIONS CAUTIONS
If you do not press any group selection button which means all group letters in the
display do not blink,
rotate the Operation Dial to increase/ decrease the power of all
groups. For example, A: 1/256, B: 1/8 + 0.6EV, C: 1/4, D: 1/2, do not select any
group then rotate the Operation Dial clockwise with 2 intervals, it becomes
A: 1/256 + 0.6EV , B: 1/4 + 0.3EV, C: 1/4 + 0.6EV, D: 1/2 + 0.6EV.
(*) The integer step values of Nissin Air 10s are
1/1, 1/2, 1/4, 1/8, 1/16, 1/32, 1/64, 1/128 and 1/256
B
C
D
A
M mode
All the following setting have to be carried out on the control of the
commander order on the commander Air 10s.