Nissin MG10 Wireless Flash with Air 10s Commander (Nikon) - Manual (Page 19)

18
Modeling light
Normal flashguns have a very short flash duration. In order to estimate and
control the flash more efficiently, the modeling light on slave unit can be used.
It is a constant light for the user to estimate and preview the light
before shooting(flash emitting).
CAUTIONS CAUTIONS
If you do not press any group selection button, which means all group letter in the
display do not blink
, pressing the modeling light button will invert the modeling on/off
setting of all groups. For example, A & C: On and B & D: off, press the modeling
light button without selecting any group, will cause to A & C: Off, and B & D: On.
1. Press the Group Selection button(s), the group letter(s) blink.
2. Press to switch the group’s modeling on/off.
3. Press the Group Selection button again when setup completed.
Turn on/off the modeling light
1. Press on Air 10s for 1 second to switch to the
advanced groups.
2. Press to change to M mode.
2. Press to turn on modeling light.
3. Use the to adjust the modeling light power.
Adjusting modeling light