Bolt VM-1010C TTL Macro Flash - Manual (Page 27)

VM-1020 Transceiver Settings and Controls | 27
3. Press the Set [ ] button to highlight and change the flash group’s power. Use the Adjustment dial to select
the power level in six steps from 1/4 to 1/128.
4. Press the Info [ ] button until the number of shots is flashing. Use the Adjustment dial to select the number
of shots from 0 to 90 (selection is based on the camera’s shutter speed).
5. Press the Info [ ] button until the frequency of shots is flashing. Use the Adjustment dial to select the
frequency from 1 to 199 Hz.
6. Press the Set [ ] button to confirm the settings.
7. Mount your Canon Speedlite on a second VM-1020 transceiver, and set the transceiver to Slave mode (see
Slave Mode below). Make sure both transceivers are set to the same channel and the slave is set to the
desired group.