Godox AD300pro Outdoor Flash - Manual (Page 9)

4. Wireless ID Settings
Press the MENU button to enter C.Fn to
choose OFF or any figure from 01-99.
Note: This can only be used when the master
unit possesses the wireless ID function.
AD300Pro adopts Godox 2.4G wireless X system, which has good compatibility with other
products of our company. As a Slave unit, AD300Pro is automatically compatible with
Canon/ Nikon/ Sony TTL system according to the master unit. Nikon cameras (use X1T-
N), Canon cameras (use X1T-C) and Sony cameras (use X1T-S) can use one or more
AD300Pro-TTL flashes simultaneously.
Wireless Flash Shooting: Radio (2.4G) Transmission
1 . Wireless Settings
Press the wireless selection button to switch wireless function ON/ OFF.
Turn the wireless function on, the < > icon will be displayed on the VA panel.
When using the FT-16 remote control or others trigger, please turn off the wireless
function.
2. Setting the Communication Channel
If there are other wireless flash systems nearby, you can change the channel IDs to
prevent signal interference. The channel IDs of the master unit and the Slave unit(s) must
be set to the same.
Long press the 1
Button for 2 seconds, so
that the icon will be
displayed on the VA panel.
Turn the Select Dial to 2
choose a channel ID from
1 to 32.
Press the button to 3
confirm.
3 . Setting the Communication Group
Short press the < GR/CH > button to choose group ID from A to E.
Positioning and Operation Range
(Example of wireless flash shooting)
● Autoflash Shooting with One Slave Unit
● Use the supplied stand to position the Slave unit.
● Before shooting, perform a test flash and test shooting.
● The transmission distance might be shorter depending on the conditions such as
positioning of Slave units, the surrounding environment and whether conditions.
● With a lot of wireless signal interference conditions, if you miss flash, please
change the wireless communication channel.
Transmission distance is
about 100m
Wireless Multiple Flash Shooting
You can divide the Slave units into two or three groups and perform TTL autoflash while
changing the flash ratio (factor). In addition, you can set and shoot with a different flash
mode for each firing group, for up to 5 groups.
● Auto Shooting with Two Slave Groups
● Auto Shooting with Three Slave Groups
A
B
A
B
C
When using the AD300Pro and Godox X2 series trigger together ， the X2 can control the flash function such as:
● Flash Mode: TTL, M, Multi ● Sync Mode: First-curtain sync, second-curtain sync and High-speed sync
● Control the power level ● Modeling Lamp turn on or off ● Beeper turn on or off2
- 36 - - 35 -