Godox AD300pro Outdoor Flash - Manual (Page 10)

Zooming Function
Separately purchase a S2 bracket to achieve
zooming function.
When installed onto the S2 bracket, AD300Pro
can move back and forth to achieve zooming
function and gain spotlight or diffused effects.
Other Applications
Sync Triggering
The Sync Cord Jack is a Φ3.5mm plug. Insert a trigger plug here and the flash will be
fired synchronously with the camera shutter.
The following table lists the Available and unAvailable custom functions of this flash.
1. Press the
● Turn the SET Selection Dial to select the custom function No.
3. Change the setting
● Press < SET > button and the Setting No. blinks.
● Turn the SET Select Dial to set the desired number. Press < SET > button will
confirm the settings.
4. Exit C.Fn menu
● Press < MENU > button to exit.
C.Fn: Setting Custom Functions
Settings &
Descriptions
ON
OFF
OFF
S1 mode
S2 mode
OFF
Auto standby
without
any operation
Can be triggered
as second curtain
OFF
ON: Trigger 2 times
for 1 cycles,
1th flash of trigger.
ON: Trigger 2 times
for 1 cycles,
2th flash of trigger.
Display
Not display
OFF
OFF
ON
Restrictions
NO
M mode
NO
M/Multi mode
M mode
M mode
Wireless mode
M non-high-speed
mode
Setting
Signs
ON
OFF
OFF
S1
S2
OFF
30 min
60 min
90 min
OFF,
0.01~30s
OFF
n1
n2
ON
OFF
OFF
01-99
OFF
ON
Functions
Beeper
S1/S2 mode
selection
Auto standby
Delay flash
Mask
t0.1 display
ID Setting
Stable Color
Temperature
Mode
Custom Function
Signs
F1
F2
F3
F4
F5
F6
F7
F8
Choose any figure from 01-99
1. Disturbed by the 2.4G signal in outer environment (e.g. wireless base station, 2.4G wifi router,
Bluetooth, etc.)
→ To adjust the channel CH setting on the flash trigger (add 10+ channels) and use the channel which is not
disturbed. Or turn off the other 2.4G equipment in working.
2. Please make sure that whether the flash has finished its recycle or caught up with the continuous
shooting speed or not(the flash ready indicator is lighten) and the flash is not under the state of
over-heat protection or other abnormal situation.
→ Please downgrade the flash power output. If the flash is in TTL mode, please try to change it to M mode(a
preflash is needed in TTL mode).
3. Whether the distance between the flash trigger and the flash is too close or not
→ Please turn on the “close distance wireless mode” on the flash trigger ( ＜ 0.5m):
X2 & X1 series: press the test button and hold on, then turning it on until the flash ready indicator blinks for 2
times.
XPro series: Set the C.Fn-DIST to 0-30m.
4. Whether the flash trigger and the receiver end equipment are in the low battery states or not
→ Please replace the battery(the flash trigger is recommended to use 1.5V disposable alkaline battery).
The Reason & Solution of Not Triggering in Godox 2.4G Wireless
- 37 - - 38 -