beautypg.com

Flash mode — ttl autoflash, Flash mode — m: manual flash, Modeling lamp – Godox AD300pro Outdoor Flash User Manual

Page 7: Wireless flash mode

background image

Flash Mode — TTL Autoflash

This flash has three flash modes: TTL, Manual (M), and Multi (Stroboscopic). In TTL
mode, the camera and the flash will work together to calculate the correct exposure for
the subject and the background. In this mode, multiple TTL functions are Available: FEC,
FEB, FEL, HSS, second curtain sync, modeling flash, control with the camera’s menu
screen.
* Press < > Mode Selection Button and three flash modes will display on the VA panel
one by one with each pressing.

TTL Mode

Press < > Mode Selection Button to enter TTL mode. The VA panel is displayed >.

High-Speed Sync

High Speed Sync (FP flash) enables the flash to synchronize with all camera shutter
speeds. This is convenient when you want to use aperture priority for fill-flash portraits.

Please use the X2 series

2

transmitter to trigger.

Long Press Wireless Button

1

< > for 2 seconds so that
< > is displayed.

With high-speed sync, the faster the shutter speed, the shorter the effective flash range.

● Multi flash mode cannot be set in high-speed sync mode.
● Over-temperature protection may be activated after 20 consecutive high-speed sync

flashes.

The flash output is adjustable from 1/1 full power to 1/256th power in 1/10th step or 1 step
increments. To obtain a correct flash exposure, use a hand-held flash meter to determine
the required flash output.

Press < > button so

1

that < M > is displayed.

Turn the Select Dial or press the SET button and turn the Select

2

Dial simultaneously to set the flash output. The flash output will
be adjustable from 1/10th increasment or 1 step increasment by
turning the Select Dial directly or pressing the SET button and
turn the Select Dial simultaneously.

Flash Mode

— M: Manual Flash

MODE

MODE

MODE

Modeling Lamp

1. Power on/off the modeling lamp:

short

press the < > to control the modeling

lamp's on or off.

2. Setting:

long press the < > to enter

modeling lamp setting.

2.1 Brightness setting: press the SET
button and the brightness value is
blinking. Turn the select dial to change the
brightness value from 1 to 10 level.
2.2 Color temperature setting: press the
SET button and the color temperature
value is blinking. Turn the select dial to
change the color temperature value from
3000K to 6000K(±500K).

Wireless Flash Mode

AD300Pro can only be set as slave unit (receiver end). Short press the wireless selection
button to switch the radio transmission function.

Wireless Mode

OFF

Radio Transmission

Flash Mode

M / Multi

TTL / M / Multi

- 32 -

- 31 -