Yamaha CVP-705B - Manual (Page 28)

Vocal Harmony Settings
CVP-709/CVP-705 Reference Manual
28
By editing the parameters of the preset Vocal Harmony type, you can create your original Vocal Harmony type.
1
Touch the Vocal Harmony name to call up the Vocal Harmony Selection display.
2
Select the desired Vocal Harmony type.
3
Depending on the selected Vocal Harmony type, edit the relevant settings as desired.
 Harmony
Lets you edit the Vocal Harmony parameters.
Editing the Vocal Harmony Type
Harmony
On/Off Turns Vocal Harmony on or off.
Mode Although one of the three following Modes is automatically selected when a Vocal
Harmony type is selected, you can change the Mode.
Chordal The harmony notes are determined by the following three chord
types: chords played in the chord section of the keyboard (with
[ACMP ON/OFF] turned on), chords played in the left hand
section of the keyboard (with the Left part turned on), and chords
contained in Song data for controlling the harmony. (Not available
if the Song does not contain any chord data.)
NOTE If you want to apply Vocal Harmony by pressing the chords in the
chord section when the Style is stopped, you need to set the “Stop
ACMP” parameter to a setting other than “Disabled” in the Style
Setting display (
page 78 ).
Vocoder The microphone sound is output via the notes you play on the
keyboard or via the Song playback notes.
Vocoder-Mono Basically the same as the Vocoder. In this mode, only single-note
melodies or lines can be played back (with last-note priority).
(When the Mode is set to “Chordal”)
Chord
Source Determines which data or event of a Song will be used for chord detection.
• Off: Detects no chord from the Song data.
• XF: Chord data defined via XF will be used.
• 1 – 16: Detects a chord from notes of the MIDI channel specified here.
When the Mode ( ) is set to “Chordal”: When the Mode ( ) is set to “Vocoder” or “Vocoder-Mono”: