Yamaha PSR-S770 - Manual (Page 101)

PSR-S970/S770 Reference Manual 101
8
Micr
ophone/Guit
ar Input
 EFFECT parameters (selected by [E]/[J] buttons)
Editing the DETAIL Tab Parameters
Use the [B]–[E] buttons to select the BAND PASS FILTER 1–5 or 6–10, then set the
value by using the [1
]–[5 ] buttons.
NOTE Feedback (howling) may result depending on the setup settings. Be careful especially when you increase values.
 BAND PASS FILTER 1–10 parameters
Determines each output gain of the BPF 1–10 for the Inst Input (keyboard performance sound). The BPF 1
corresponds to the lowest Formant while the BPF 10 corresponds to the highest Formant.
Settings:
-18dB – +18dB
[4 ]/
[5 ] TYPE Determines the specific type of effect applied to the lead Synth Vocoder
sound. A wide range of reverb, delay, modulation, distortion and other
special effects are available. You can edit the vocal effect by pressing
the [G] (VOCAL EFFECT EDIT) button (step 2 on
page 99 ).
For a list of the effect types, refer to the Data List on the website.
[6 ] DEPTH Determines the amount of the effect (selected in TYPE above) applied
to the overall Synth Vocoder sound.
[7 ] REVERB Determines the amount of reverb applied to the overall Synth Vocoder
sound.
[8 ] CHORUS Determines the amount of chorus effect applied to the overall Synth
Vocoder sound.