H3C Technologies H3C S6800 Series Switches - Manual (Page 301)

288
Step Command Remarks
7. Enable the PE to exchange
labeled routes with the
ASBR-PE in the same AS.
peer { group-name | ip-address
[ mask-length ] }
label-route-capability By default, the PE does not
advertise labeled routes to any
IPv4 peer/peer group.
8. Return to BGP view. quit N/A
9. Enter BGP VPNv6 address
family view.
address-family vpnv6 N/A
10. Enable the PE to exchange
BGP VPNv6 routing
information with the EBGP
peer.
peer ip-address [ mask-length ]
enable
By default, the PE does not
exchange labeled routes with any
IPv4 peer/peer group.
Configuring the ASBR-PEs
In the inter-AS IPv6 VPN option C solution, an inter-AS LSP is needed, and the routes advertised between
the PEs and ASBRs must carry MPLS label information. The configuration is the same as that in the
Inter-AS IPv4 VPN option C solution. For more information, see " Configuring MPLS L3VPN ."
Configuring the routing policy
A routing policy on an ASBR-PE does the following:
• Assigns MPLS labels to routes received from the PEs in the same AS before advertising them to the
peer ASBR-PE.
• Assigns new MPLS labels to the labeled routes to be advertised to the PEs in the same AS.
The configuration is the same as that in the Inter-AS IPv4 VPN option C solution. For more information,
see "
Configuring MPLS L3VPN ."
Configuring an OSPFv3 sham link
Before you configure an OSPFv3 sham link, configure basic IPv6 MPLS L3VPN (OSPFv3 is used between
PE and CE).
Configuring a loopback interface
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a loopback interface
and enter loopback interface
view.
interface loopback interface-number
By default, no loopback
interface is created.
3. Associate the loopback
interface with a VPN instance. ip binding vpn-instance
vpn-instance-name
By default, the interface is
associated with no VPN
instance.
4. Configure an IPv6 address for
the loopback interface.
See Layer 3—IP Services
Configuration Guide.
By default, no IPv6 address is
configured for the loopback
interface.