H3C Technologies H3C S6800 Series Switches - Manual (Page 25)

12
Configuring a static LSP
Overview
A static label switched path (LSP) is established by manually specifying the incoming label and outgoing
label on each node (ingress, transit, or egress node) of the forwarding path.
Static LSPs consume fewer resources, but they cannot automatically adapt to network topology changes.
Therefore, static LSPs are suitable for small and stable networks with simple topologies.
Follow these guidelines to establish a static LSP:
• The ingress node does the following:
a. Determines an FEC for a packet according to the destination address.
b. Adds the label for that FEC into the packet.
c. Forwards the packet to the next hop or out of the outgoing interface.
Therefore, on the ingress node, you must specify the outgoing label for the destination address (the
FEC) and the next hop or the outgoing interface.
• A transit node swaps the label carried in a received packet with a specific label, and forwards the
packet to the next hop or out of the outgoing interface. Therefore, on each transit node, you must
specify the incoming label, the outgoing label, and the next hop or the outgoing interface.
• If the penultimate hop popping function is not configured, an egress node pops the incoming label
of a packet, and performs label forwarding according to the inner label or IP forwarding. Therefore,
on the egress node, you only need to specify the incoming label.
• The outgoing label specified on an LSR must be the same as the incoming label specified on the
directly connected downstream LSR.
Configuration prerequisites
Before you configure a static LSP, complete the following tasks:
• Identify the ingress node, transit nodes, and egress node of the LSP.
• Enable MPLS on all interfaces that participate in MPLS forwarding. For more information, see
"
Configuring basic MPLS ."
• Make sure the ingress node has a route to the destination address of the LSP. This is not required on
transit and egress nodes.
Configuration procedure
To configure a static LSP:
Step Command Remarks
1. Enter system view. system-view N/A