H3C Technologies H3C S12500-X Series Switches User Manual

Page 84

[SwitchB-vsi-vpnc] gateway vsi-interface 3

[SwitchB-vsi-vpnc] quit

Configure Switch C:
# Enable L2VPN.

system-view

[SwitchC] l2vpn enable

# Reserve global-type VLAN interface resources. In this example, VLAN-interfaces 3000 to 3500
are reserved.

[SwitchC] reserve-vlan-interface 3000 to 3500 global

# Create the VSI vpna and VXLAN 10.

[SwitchC] vsi vpna

[SwitchC-vsi-vpna] vxlan 10

[SwitchC-vsi-vpna-vxlan10] quit

[SwitchC-vsi-vpna] quit

# Create the VSI vpnb and VXLAN 30.

[SwitchC] vsi vpnb

[SwitchC-vsi-vpnb] vxlan 30

[SwitchC-vsi-vpnb-vxlan30] quit

[SwitchC-vsi-vpnb] quit

# Assign an IP address to Loopback 0. The IP address will be used as the source IP address of the
VXLAN tunnels to Switch A and Switch B.

[SwitchC] interface loopback0

[SwitchC-Loopback0] ip address 3.3.3.3 255.255.255.255

[SwitchC-Loopback0] quit

# Create a VXLAN tunnel to Switch A. The tunnel interface name is Tunnel 1.

[SwitchC] interface tunnel 1 mode vxlan

[SwitchC-Tunnel1] source 3.3.3.3

[SwitchC-Tunnel1] destination 1.1.1.1

[SwitchC-Tunnel1] quit

# Create a VXLAN tunnel to Switch B. The tunnel interface name is Tunnel 3.

[SwitchC] interface tunnel 3 mode vxlan

[SwitchC-Tunnel3] source 3.3.3.3

[SwitchC-Tunnel3] destination 2.2.2.2

[SwitchC-Tunnel3] quit

# Assign Tunnel 1 to VXLAN 10.

[SwitchC] vsi vpna

[SwitchC-vsi-vpna] vxlan 10

[SwitchC-vsi-vpna-vxlan10] tunnel 1

[SwitchC-vsi-vpna-vxlan10] quit

[SwitchC-vsi-vpna] quit

# Assign Tunnel 1 and Tunnel 3 to VXLAN 30.

[SwitchC] vsi vpnb

[SwitchC-vsi-vpnb] vxlan 30

[SwitchC-vsi-vpnb-vxlan20] tunnel 1

[SwitchC-vsi-vpnb-vxlan20] tunnel 3

[SwitchC-vsi-vpnb-vxlan20] quit

This manual is related to the following products: